Filter
Top Products
RoadRunners BRR-L & BRR-LA Programming guide Nov 2007
© Baracoda 2007 3/29
1/ Introduction
Please verify that your Roadrunners has a firmware version equal or superior to 3.1 before using it with this
programming Guide. Some functionality may not work with older versions of the firmware. Refer to the
BaracodaManager documentation in order to know how to upgrade your scanner.
The RoadRunners can be programmed by scanning barcode labels which contain commands for the 1D decoder.
Programming labels must be Code128, with specific starting and ending characters. These labels will always be
read, even if Code128 symbology is disabled.
The scanner will acknowledge a good and valid programming bar code label reading with two beeps and a green
enlightening of both leds. It will give two other beeps (lower tone) and a red enlightening of the RSL led for either
an invalid or bad reading.
Please do not read the programming barcodes while being connected to the BaracodaManager.
Programmable options are divided into 2 groups. The first group includes the options that show the general
behaviour of the scanner. The second group sets the decoding parameters for each barcode symbology.