Filter
Top Products
Baracoda USB Plug &
Scan dongle
4. Scanner
configuration: ‘Batch mode’
4.1 Explanations
BEHAVIOUR
For a user application requiring batch mode feature, please
the scanner settings to which it gets connected in the
So it
’s very important before connecting a new scanner using Batch mode (and with datas in its
Batch memory) to check that the RS232 Plug & Scan is already configured in Batch mode, and not
in Real Time mode. So you have to respect the following process:
1) Associ
ate the scanner to the RS232 Plug&Scan
2)
Configure your scanner in Batch mode AFTER (by scanning the configuration barcodes
available in this document), and start your work.
The upload process consists of
temporarily switching the scanner into Real time with “no data loss mode” ON
(all the barcodes or RFID Tag ID in memory will be sent using the no data loss protocol). Then the scanner
switches back to batch mode when all the barcodes are properly sent.
Notes:
•
This functionality is only available for USB Plug&Scan dongles with firmware version 3.10 and newer
(see “Print Firmware Version” section for how to get the firmware version).
•
If there is a lot of barcode
emulate the data.
4
.2 Enable ‘batch mode’
When this mode is set, all the scanners (supporting the functionality) working with the dongle are set in batch
mode: all scanned data (barcodes, TagID) are stored in the flash
Scan dongle
– User Guide v3.33b
configuration: ‘Batch mode’
For a user application requiring batch mode feature, please
note that the
the scanner settings to which it gets connected in the
last
configuration used by the
’s very important before connecting a new scanner using Batch mode (and with datas in its
Batch memory) to check that the RS232 Plug & Scan is already configured in Batch mode, and not
in Real Time mode. So you have to respect the following process:
ate the scanner to the RS232 Plug&Scan
FIRST
(by scanning its CONNECT barcode).
Configure your scanner in Batch mode AFTER (by scanning the configuration barcodes
available in this document), and start your work.
temporarily switching the scanner into Real time with “no data loss mode” ON
(all the barcodes or RFID Tag ID in memory will be sent using the no data loss protocol). Then the scanner
switches back to batch mode when all the barcodes are properly sent.
This functionality is only available for USB Plug&Scan dongles with firmware version 3.10 and newer
(see “Print Firmware Version” section for how to get the firmware version).
If there is a lot of barcode
s to upload, notes that the USB Plug&Scan take
s a long time to receive &
.2 Enable ‘batch mode’
When this mode is set, all the scanners (supporting the functionality) working with the dongle are set in batch
mode: all scanned data (barcodes, TagID) are stored in the flash
memory.
Enable batch mode
- 8 -
Data Capture
for Workforce
in Motion
note that the
USB Plug&Scan forces
configuration used by the
USB dongle.
’s very important before connecting a new scanner using Batch mode (and with datas in its
Batch memory) to check that the RS232 Plug & Scan is already configured in Batch mode, and not
(by scanning its CONNECT barcode).
Configure your scanner in Batch mode AFTER (by scanning the configuration barcodes
temporarily switching the scanner into Real time with “no data loss mode” ON
(all the barcodes or RFID Tag ID in memory will be sent using the no data loss protocol). Then the scanner
This functionality is only available for USB Plug&Scan dongles with firmware version 3.10 and newer
s a long time to receive &
When this mode is set, all the scanners (supporting the functionality) working with the dongle are set in batch