Filter
Top Products
1. Remove the projector lens.
2. Use the mounting screws (2) to mount the baseplate (1) to the underside of
the projector.
3. Loosen the 2 connection screws on the lens ring bracket and remove the
upper lens ring bracket (6).
4. Check that the shim (4) position is correct for the type of lens you are
using.
5. Loosely mount the lower lens ring bracket (5) to the sliding rail (3). Do not
over tighten.
6. Replace the projector lens. If required, adjust the lens settings.
7. Replace the upper lens rings bracket (6) and tighten the 2 connection
screws rmly.
8. Tighten the lower lens ring/sliding rail screws rmly.
Procedure
EN52, EN54
EN521 EN53,
EN55, EN56,
EN57
EN51, EN53,
EN55, EN56,
EN57
EN52, EN54,
Mounting on different lenses
Before mounting the lens support kit on the EN52 and EN54 lenses, the
lower lens ring bracket should be rearranged so that the shim is on the side
furthest from the projector.
Installation