Filter
Top Products
Copyright ©
All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be recorded, transmitted or
stored in a retrieval system without the pr ior written consent of BARCO .
Guaran tee and Compensation
Barco provides a guarantee relating to perfect manufacturing as part of the legally stipulated terms of guarantee. On receipt, the purchaser
must immediately inspect all delivered goods for damage incurred during transport, as well as for material and manufacturing faults Barco
must be informed immediately in writing of any complaints.
The period of guarantee begins on the date of transfer of risks, in the case of special systems and softwar
e on the date of commissioning,
at latest 30 days after the transfer of risks. In the event of justified notice of compliant, Barco can repair the fault or provide a replacement
at its own discretion within an appropriate period. If this measure proves to be impossible or unsuccessful, the purchaser ca n demand a
reduction in the purchase price or c ancellation of the contract. All other claims, in particular t
hose relating to compensation for direct or
indirect damage, and also damage attributed to the operation of software as well as to o ther services pr ovided by Barco, being a component
of the s ystem or independent service, will b e deemed invalid provided the damage is not proven to be attributed to the absence of properties
guaranteed in writing or due to the intent or gross negligence or part of Bar co.
If the pur chaser or a third party carries out modifications or repairs on good delivered by Barco, or if the goods are handled incorrectly,
in particular if the systems a re commissioned operated incorrectly or if, after the transfer of risks, the goods are s ubject to influences not
agreed upon in the contract, all guarantee claims of the purchaser will be rendered invalid. Not inc luded in the guarantee cove rage are
system failures which are attributed to programs or special electronic circuitry provided by the purchaser, e.g. interfaces. Normal wear as
well as normal maintenance are not subjec t t o the guarantee p rovided by Barco either.
The environmental conditions as well as the servicing and maintenance regulations specified in the this manual must be complied with by
the customer.
Changes
Barco provides this manual “as is” without warranty of any kind, either expressed or implied, including but not limited to the implied war-
ranties or merchantability and fitness for a particular purpose. Barco may make improvements and/or changes to the product(s) and/or the
program(s) described in this publication at any time without notice.
This pub lication could contain technical inacc uracies or
typographical errors. Changes are periodically made to the information in this
publication; these c hanges are incorporated in new editions of this publication.
Trademarks
Brand and product name s mentioned in this manual may be trademarks, registered trademarks or copyrights of their respective holders.
All brand and product names me ntioned in this man ual serve as comments or examples and are not to be understood as advertising for
the products or their manufactures.
Federal Communication Commission (FCC Statement)
This equipment h as been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against h armful interference when the equipment is operated in a residential
environment. This equipm ent generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may caus e harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user is encouraged to try to correct the interference by one or more of the following measures.
Introduction to the user :
If this equipment does cause interfere
nce to radio or television reception, the user may try to correct the interference by one or more of the
following measures :
• Re-orientation of the receiving antenna for the radio or television.
• Relocate the equipment with respect to the receiver.
• Plug the equipment into a different outlet so that the equipment and receiver a re on different branch circuits.
• Fasten cables connectors to the equipment by mounting screws.
The use o f shi elded cab les is required to com ply w ithin the limits of Part 15 of FCC rul es an d E N55022.