Filter
Top Products
3. Physical Installation of the D320PL Digitizer
3. PHYSICAL INS TALLATION OF THE
D320PL DIGITIZER
3.1 Installatio n r equ irements
Requirements
• The D320PL Digitizer should not be placed in a b uilt-in installation or enclosure unless proper venti-
lation is provided.
• When using the unit in a multi-unit r ack assembly or closed assembly, the ambient temperature inside
the assembly may not exceed the maximum rated ambient temperature of the Digitizer. The instal-
lation should be such that the amount of air flow required for safe operation of the equipment in not
compromised.
• When building in the D320PL Digitizer into a rack with cover door, be a
ware that a space of 8,5 cm is
needed between the indicated reference and the cover door. This space is needed to guide the input
cables to the inputs.
Image 3- 1
A Reference
• The D320PL Digitizer will require that air flo
ws freely in vent holes. Blocking these holes will greatly
reduce the reliability of the unit and lead to the possibility of overheating.
• The D320PL Digitizer should operate from an AC power source. The D320PL Digitizer is equipped
with Power Supply Autoranging from 85 to 264 volt (50–60 Hertz).
• When installed in a rack, the mounting should be such that no hazardous condition is achieved due
to uneven mechanical loading.
• When the mains switch located on the back of the D320PL Digitizer is not accessible due to rack
mounting, the socket outlet supplying the rack shall be installed near the equipment and be easily
accessible or a readily accessible disconnect device shall be incorporated in the fixed wiring. When
using a rack in an installation is advisable to log the serial number of the device and to activate the
warranty figure by registering utilizing the included form.
• Do not place the D320PL Digitizer on an unstable cart, stand or table. T he device may fall, causing
serious damage to it.
R5976470 D320PL DIGITIZER 13122002
11