Filter
Top Products
2. Kit installation
Image 2-2
side screw
4. Take the server out of the input box
Image 2-3
Server removed from the input box
2.2 Remo ving the video inputs (layer 1 and layer 2)
How to remove the video inputs ?
1. Refer to the service manual for the detailed p
rocedure
2.3 Video Board adaptation
What has to be done ?
To avoid disturbances on video sources when the new SBC is active, the hum circuit of the video board has to be disabled (pertur-
bations induced by SBC supply voltage). This can be done by unsoldering the resistors R71 and R80 (see procedure below).
The video board is the board located on layer 1. For more information on how to remove this board refer to
the service manual.
How to adapt the board ?
1. Unsolder the indicated resistors.
4
R5976950 SERVER UPGRADE KIT FOR BARCO IQ PRO 15/02/2006