Filter
Top Products
Documentation Number 3PCIOSD1x-3903m Manual Chapter 3 29
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Comm. Pk. – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
12. Verify 1 new COM Port. (shown here as COM5)
If you have 1 new COM port, the installation is complete. Select the
port, select Settings, Advanced. You should obtain the message,
"There are no user configurable Advanced I/O parameters for this
COM port."
Check the port with your software or with a Loopback test.
NOTE: In the above example, a serial mouse is connected to the
port which would usually be COM1. NT does not show it. COM2 is
the second built-in serial port.
continued next page
30 Chapter 3 Documentation Number 3PCIOSD1x-3903m Manual
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Comm. Pk. – Oranmore, Galway, Ireland – Ph 353-91-792444 – Fax 353-91-792445
You can check details of the serial card setup using Windows NT
Diagnostics, found under Administrative Tools. This can show the
Resources used such as addresses and IRQ.
Windows Diagnostics will not allow changing anything.
The above shows one port using PCI card interrupt.
continued next page