Filter
Top Products
32
Bay 8:
L7 & R8 equals the L/R recording input to the 2-tracks. On Bay 8 we have hard-wired these to recording
outputs 1 to 6 in order to drive all recorders simultaneously. Copying from any 2-track source to all recorders
may be done by patching the source outputs into L7 and R8.
We have assumed you have a HiFi amp available to enable a variety of secondary sources to be condensed
into the XTRN (external) input for easy monitoring selection via the HiFi amp’s input selector switch, if you
want to record from any of these sources, best patch direct from the individual outputs (17 to 22) rather than
the HiFi amp mix (15 and 16) for the cleanest result. (The exception being vinyl, which will need to use the HiFi
amp’s RIAA pre-amp to present the mixer with a flat response signal).
Fig. 8.2: Wiring for bay 8 (for advanced wiring scheme refer to section 11)
8.3 Looming problems
Loom wiring is an art unto itself, and it is worth taking time out to get it right. First off, it is important to avoid
earth loops. (A looped wire acts as an ariel, picking up electromagnetic radiation.) Think of a tree. Every part
of that tree is connected to every other part, but only by one route. That’s how the total earth picture for your
entire studio should look. Don’t take the earth off your power cable plug to reduce audible 50 Hz mains hum
(or it’s harmonics). Rather you should be looking at disconnecting the signal screen somewhere.
You could do worse than ensure that all screens are commoned at the patchbay in which case all unearthed
equipment would pick up earth from this point via a single screen (more than 1 route = an earth loop), while
mains-earthed equipment would have all screens cut at the equipment end.
+ Some quality equipment has an independent signal and mains earth. In this case at least one,
and possibly all, screens should carry earth to the equipment. Sometimes the only way to find
out is “suck and see”.
Take care to ensure that using the patchbay does not disturb the studio’s earth architecture. Always use short
as possible patch leads with the screen connected at both ends.
If you’re really serious about hum levels, you could run balanced lines wherever appropriate. The earth wiring
scheme would be the same as before. By shorting the ring to the barrel for all balanced jack sockets
connected to unbalanced equipment, you could use balanced patch leads throughout. (There is no percentage
in wiring a balanced output to a balanced input with a mono patch cord!) (See section 12 “(UN)BALANCED
LINES”.)