Filter
Top Products
USING THE BELKIN WIRELESS LAN CONFIGURATION UTILITY
Proceed with the following instructions for configuring your network profiles. The
instructions explain how to open the Utility and how to use it to configure a
network profile.
When you launch the Wireless LAN Utility (the Utility), you will be presented
with the “Connect to Wireless Network” screen.
The following small icon will also be present in your system tray.
Once installed, the Wireless LAN Utility will automatically display when Windows
boots up.
The Utility can be set to always show up in your system tray. You can hide the
icon if you right-click on it in your system tray. Although no icon will be
displayed, your preferred network will continue to be managed by the Card. The
system tray icon can be re-enabled from the Wireless LAN Configuration Utility,
available from the Control Panel.
Single-clicking on the icon in the system tray will open the window.
Note: You may double-click on the Utility icon on your system tray to go directly to
the “Advanced Configuration” window.
INSTALLING AND SETTING UP THE CARD
12
Connecting to your Wireless Network
If you already have a wireless router or an access point in your home or office,
the Card will automatically attempt to connect to your wireless network. In most
cases, the Card will be able to connect to your network automatically. If your
wireless network is using encryption, you will need to set the encryption settings
of your Card to match that of your wireless network. For information about
configuring your Card, see the next section in this manual.
Uninstalling the Software and Drivers
If you need to remove the software and drivers for any reason, you can easily
accomplish this in one of two ways. You can insert the software CD and click on
the “Uninstall” option in the menu, or you can go to the Windows Control Panel
and select the “Add/Remove Programs” option. The Belkin Wizard will walk you
through the removal process.
12 13