Filter
Top Products
4
EN
4
1. Plug the AC adapter into a wall outlet or surge suppressor. Plug the DC
connector into the DC power jack found on the side of the Hub.
Note: The Hub may be used without the power supply when connecting
low-power devices such as keyboards and mice. Remove the USB A cable
connector from its built-in storage bay, then plug it into the downstream port
of your computer, or downstream port of another hub (see Fig. 1).
Important Note: The Hub must be connected to a USB 2.0-compliant host
in order to function in high-speed mode (480Mbps data rate). If the Hub is
connected to a USB 1.1-compliant host, it will operate only in low-speed or
full-speed mode (1.5Mbps/12Mbps).
Installation
Fig.1
Upstream port
Port 1
Port 2
Port 3
Port 4