Filter
Top Products
16
Maintenance
1
2
3
4
5
6
The following sections provide maintenance information and
troubleshooting advice.
Troubleshooting
1. I have gone through the association procedure, but
still cannot connect to the Hub.
Check that the power supply is connected and that the blue
LED on the Hub is lit.
If you are sure there is power to the Hub, open the Wireless
USB Manager. On the opening screen, your Hub should be
one of the devices listed. If it is not, perform the cable- or
PIN-association procedure again.
If you see your device listed, make sure there are two green
arrows pointing to each other over the device icon. If the
software does not show a wireless connection, move your
Hub closer to the computer to see if that fixes the problem.
If neither of those steps work, try resetting your Hub by
unplugging the power-supply connector from the back of
the Hub, waiting a few moments, and then plugging it back
in.
Note:
After doing this, you must repeat the security-
association setup.