Filter
Top Products
3131
31
2
1
3
4
5
6
7
10
Troubleshooting
8
9
section
If the Print Server has been configured before, and the IP
address has already been set to another subnet, the best solution
is to restore factory defaults on the Print Server. Do this by
holding down the reset button while repowering the Print Server.
After a reset, the Print Server will generally receive an IP address
in the correct subnet.
“No printer” error screen appears during setup. In most cases,
this error occurs when the printer is not powered on, or it is not
enabled (or online). After you have checked this, make sure that
it is not out of paper or jammed. Some printers “sleep” after
periods of inactivity. In any of these cases, restore the printer to
functionality, then, if necessary, reboot the Print Server. Some
USB printers are not compatible with Print Servers. To check the
Belkin website for compatibility information, go to: http://web.
belkin.com/support/F1UP0301.