Filter
Top Products
11
G Wireless Router
SECTIONSTable of Contents 1 2 4 5 6 7 8 9 103
KNOWING YOUR ROUTER
7� Power Jack
Connect the included 5V DC power supply to this jack.
8� Connections to Computers (Wired Computer Ports) – Gray
Connect your wired (non-wireless) computers to these ports. These ports
are RJ45, 10/100 auto-negotiation, auto-uplinking ports for standard UTP
category 5 or 6 Ethernet cable. The ports are labeled 1 through 4. These
ports correspond to the numbered LEDs on the front of the Router.
9� Connection to Modem (Modem Port) – Yellow
This port is for connection to your cable or DSL modem. Use the cable
that was provided with the modem to connect the modem to this port. Use
of a cable other than the cable supplied with the cable modem may not
work properly.
10� Reset Button
The “Reset” button is used in rare cases when the Router may function
improperly. Resetting the Router will restore the Router’s normal operation
while maintaining the programmed settings. You can also restore the
factory default settings by using the “Reset” button. Use the restore option
in instances where you may have forgotten your custom password.
a. Resetting the Router
Push and release the “Reset” button. The lights on the Router will
momentarily flash. The “Power” light will begin to blink. When the “Power”
light becomes solid again, the reset is complete.
b. Restoring the Factory Defaults
Press and hold the “Reset” button for at least 10 seconds, then release
it. The lights on the Router will momentarily flash. The “Power” light will
begin to blink. When the “Power” light becomes solid again, the restore is
complete.