Filter
Top Products
Operation42
Controlling the projector through a Lan
environment (MP526/MP576 only)
Lan Control Settings allow you to manage the projector from a computer using a web
browser when the computer and the projector are properly connected to the same local
area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2. Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced menu
is highlighted.
3. Press to highlight Lan Control Settings and press Mode/Enter. The Lan Control
Settings page is displayed.
4. Press to highlight Control By and press / to select RJ45.
5. Press to highlight DHCP and press / to select On.
6. Press to highlight Apply and press Mode/Enter.
7. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings
page.
8. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server settings
will be displayed. Note down the IP address displayed in the Projector IP Address
row.
If the Projector IP Address still does not appear, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press to highlight DHCP and press / to select Off.
3. Contact your ITS administrator for information on the Projector IP Address,
Subnet Mask, Default Gateway, and DNS Server settings.
4. Press to select the item you want to modify and press Mode/Enter.
5. Press / to move the cursor and then press / to enter the value.
6. To save the setting, press Mode/Enter. If you do not want to save the setting, press
Menu/Exit.
7. Press to highlight Apply and press Mode/Enter.