Filter
Top Products
Introduction12
Remote control effective range
Infra-Red (IR) remote control sensor is located on the front of the projector. The remote
control must be held at an angle within 30 degrees perpendicular to the projector's IR
remote control sensor to function correctly. The distance between the remote control
and the sensor should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor on
the projector that might obstruct the infra-red beam.
Replacing the remote control battery
1. Pull out the battery holder.
Please follow the illustrated instructions. Push and hold the locking
arm while pulling out the battery holder.
2. Insert the new battery in the holder. Note the
positive polarity should face outward.
3. Push the holder into the remote control.
• Avoid excessive heat and humidity.
• There may be battery damage if the battery is incorrectly
replaced.
• Replace only with the same or equivalent type recommended by
the battery manufacturer.
• Dispose of the used battery according to the battery
manufacturer's instructions.
• Never throw a battery into a fire. There may be danger of an explosion.
• If the battery is dead or if you will not be using the remote control for a long time, remove the battery to
prevent damage to the remote control from possible battery leakage.
• Operating the projector from the front
A
p
p
r
o
x
.
+
1
5
º