Filter
Top Products
Operation18
Operation
Startup
1. Switch all of the connected equipment on.
2. Plug the power cord into the projector and into a wall socket.
3. Turn on the wall socket switch (where fitted).
4. Press and hold Power on the remote control or projector to start the unit. The Power
indicator light flashes green and stays green when the power is turned on.
5. The start up procedure takes about 30 seconds after pressing Power. In the later stage
of start up, a default BenQ logo appears.
6. Then, the projector starts to search for input signals. Irrespective of selected input
source, the screen shows the selected source information at the bottom right corner of
the screen. If there is no input source detected, the three messages will be displayed on
the screen continuously: “RGB/YPbPr Searching”, “Video Searching” and “S-Video
Searching”.
7. You can also press Source on the projector or remote control to select your desired
input signal. For more information, please refer to page 21.
If the frequency/ resolution of the input signal exceeds the projector’s operating range, you
will see the message “Out of Range” displayed on a blank screen.
Ex.