Filter
Top Products
Maintenance 35
Step 1. Turn the power off and disconnect the projector from the wall socket.
Step 2. Turn the projector over. Then loosen the
screws and remove the lamp cover. If the
lamp is hot, avoid burns by waiting for 45
minutes until the lamp has cooled.
Step 3. Move the latch to another end as shown
in the picture.
Step 4. Loosen the screw that holds the lamp to
the projector. If the screw is not loosened
completely, they could injure your fingers.
It is strongly recommended that you use a
magnetic-head screwdriver.
Step 5. Lift the handle so that it stands up. Use
the handle to slowly pull the lamp out of
the projector.
Pulling it too quickly may cause the lamp to break
and scatter broken glass in the projector.
Do not place the lamp in locations where water
might splash on it, children can reach it, or near
flammable materials.
Do not insert your hands into the projector after
the lamp is removed. If you touch the optical
components inside, it could cause color unevenness and distortion of the projected images.
Step 6. Insert a new lamp. Make sure the handle
is fully locked, move the latch back, and
tighten the screw firmly.
Loose screw may cause a bad connection, which
could result in malfunction.
Do not over tighten the screw.
Step 7. Re-install the lamp cover and tighten the
screw. Do not turn the power on with the
lamp cover removed. Whenever the lamp
is replaced, reset the total lamp operation time. Do not reset if the lamp is not
replaced as this could cause damage.