Filter
Top Products
VoIP/(802.11g) ADSL2+ Router
Chapter 4: Configuration
General Settings
You can choose not to enable Firewall, to add all filter rules by yourself, or enable the Firewall
using preset filter rules and modify the port filter rules as required. The Packet Filter is used to filter
packets based-on Applications (Port) or IP addresses.
There are four options when you enable the Firewall, they are:
All blocked/User-defined: no pre-defined port or address filter rules by default, meaning that
all inbound (Internet to LAN) and outbound (LAN to Internet) packets will be blocked. Users
have to add their own filter rules for further access to the Internet.
High/Medium/Low security level: the predefined port filter rules for High, Medium and Low
security are displayed in Port Filters of Packet Filter.
Select either High, Medium or Low security level to enable the Firewall. The only difference
between these three security levels is the preset port filter rules in the Packet Filter. Firewall
functionality is the same for all levels; it is only the list of preset port filters that changes between
each setting. For more detailed on level of preset port filter information, refer to Table 1:
Predefined Port Filter.
If you choose of the preset security levels and then add custom filters, you may temporarily disable
the firewall and recover your custom filter settings by re-selecting the same security level.
The “Block WAN Request” is a stand-alone function and not relate to whether security enable or
disable. Mostly it is for preventing any scan tools from WAN site by hacker.
57
Any remote user who is attempting to perform this action may result in blocking
all the accesses to configure and manage of the device from the Internet.