Filter
Top Products
BiPAC 7402R2 ADSL2+ VPN Firewall Router
Chapter 4: Configuration
Active PC in LAN displays a list of individual Ethernet device’s IP Address & MAC Address which
connecting to the router.
You can easily by checking the box next to the IP address to be blocked or allowed. Then, Add to insert
to the Ethernet Client Filter table. The maximum Ethernet client is 16.
Port Setting
This section allows you to configure the settings for the router’s Ethernet ports to solve some of the
compatibility problems that may be encountered while connecting to the Internet, as well allowing users
to tweak the performance of their network.
Port # Connection Type: Five options to choose from: Auto, 10M half-duplex, 10M full-duplex, 100M
half-duplex or 100M full-duplex. Sometimes, there are Ethernet compatibility problems with legacy
Ethernet devices, and you can configure different types to solve compatibility issues. The default is Auto,
which users should keep unless there are specific problems with PCs not being able to access your LAN.
IPv4 TOS priority Control (Advanced users): TOS, Type of Services, is the 2
nd
octet of an IP packet.
Bits 6-7 of this octet are reserved and bit 0-5 are used to specify the priority of the packet.
This feature uses bits 0-5 to classify the packet’s priority. If the packet is high priority, it will flow first and
will not be constrained by the Rate Limit. Therefore, when this feature is enabled, the router’s Ethernet
switch will check the 2
nd
octet of each IP packet. If the value in the TOS field matches the checked
values in the table (0 to 63), this packet will be treated as high priority.
35