Filter
Top Products
11
www.bissell.com 800.237.7691
Maintenance and care
Cleaning the filters continued
Secondary filter
1. The secondary filter is located above the
primary filter.
2. To remove the primary filter, see instructions on
page 10.
3. To remove the secondary filter, pull filter
down and out.
4. Shake filter over trash can to release any
loose debris.
5. Rinse filter with warm water.
6. To replace filter, insert into top portion of
vacuum.
Clearing clogs
Low suction or poor pickup may be due to a clog
in the vacuum. If this occurs, the LED full dirt
tank indicator light will turn yellow and indicate
airflow is restricted.
If there is no suction or if suction is reduced at
the hose, follow these steps to clear the clog:
1. Unplug vacuum from electrical outlet.
2. Check the filter and clean as necessary (see
cleaning your filters above and on page 10).
3. Check to see if dirt tank is full. Empty if
needed.
4. Check wet/dry or blower outlet for clogs.
If the clog is contained near the top of the hose
(close to the unit), follow these steps:
1. Attach hose to the wet/dry inlet and turn the
power on.
2. This should dislodge the clog by sucking in
debris.
ug110-4053_18P0_608.indd 11 6/13/08 12:35:32 PM