Filter
Top Products
23
CHAPTER 3: Configuration
For your convenience, the Converter is available
with several different twisted-pair interfaces: RJ-11
jack, RJ-45 jack, and terminal blocks with strain
relief. The Converter is also available with DB25
male or female connectors.
4.1.1 T
WISTED
-P
AIR
C
ONNECTIONS
U
SING
T
ERMINAL
B
LOCKS
If your application requires you to connect one or
two pairs of bare wires to the Converter, you will
need to open the case to access the terminal blocks.
The following instructions tell you how to open the
case, connect the bare wires to the terminal blocks,
and fasten the strain-relief collar in place so the wires
won’t pull loose.
1. You should already have the case open for the
configuration procedure. If not, see Section 3.1.
2. Strip the outer insulation from the twisted pair(s)
about one inch from the end.
Figure 4-1. Stripping the outer insulation.