Filter
Top Products
724-746-5500 | blackbox.com
Page 9
Chapter 3: Installation
3. Installation
3.1 Linking the DVI/VGA USB/PS2 1-Port Module to the ServTray
The DVI/VGA USB/PS2 1-Port Module is 1U high and is designed to connect to the ServTray via a Centronics connector.
CAUTION: Do not place cables near things that create electrical noise such as fluorescent lighting, air conditioning equipment, etc.
3.2 Hardware Installation
This section provides instructions for the basic hardware setup of a single DVI/VGA USB/PS2 1-Port Module.
CAUTION: Before you begin, make sure that power to all the devices that you will be connecting is turned off. To prevent damage
caused by ground potential differences, make sure that all devices are properly grounded. If you don’t follow these
instructions, your computers, the ServTray, and/or the DVI/VGA USB/PS2 1-Port Module could be damaged.
3.2.1 Connecting the Computer Console, Keyboard, and Mouse
1. Power off all computers.
2. Using the 3-in-1 or 2-in-1 cable (all cables included, see Figure 3-1), connect the HD15 VGA female or DVI male, keyboard, and
mouse connectors on the cable to the console VGA, keyboard, and mouse ports on the back of the module.