Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 11
Chapter 3: Installation
In the example shown in Figure 3-3, two expansion modules are connected from two separate expansion ports on the
ServSensor. In the example shown in Figure 3-4, the same two modules are connected to one expansion port in a daisychain
configuration.
Figure 3-4. Daisychained configuration.
3.2 Setting up a Sensor (Standard Configuration)
This section describes the basic setup of a dry contact sensor in a standard configuration. It focuses on the dry contact sensor;
however, this basic setup process applies to all compatible sensors. If you require information on specific functions of a particular
sensor, then download the manual for that sensor from our Web site or locate it on your product CD.
1. Plug the sensor into one of the dry contact ports on the rear panel of the unit. In this example, we will use Port 1. See Figure
3-5.
Figure 3-5. Plug the temperature sensor into Port 1.
2. Type the IP address of the unit (default, 192.168.0.100) into your browser.
3. Log in as the administrator using your administrator password (the default is “public”). The Summary page will appear as
shown in Figure 3-6.