Filter
Top Products
Page 18
724-746-5500 | blackbox.com
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches
Table 4-1 (continued). Hotkey commands.
Key Sequence Function
Left-Ctrl + Left-Ctrl + F3 To adjust Scan Rate, this command sets the
duration before switching to the next computer
in AutoScan.
The 4-Port ServSwitch DT Series generates 1 to
4 beeps, indicating a scan interval of 3, 8, 15,
and 30 seconds respectively.
Left-Ctrl + Left-Ctrl + F5 Audio Stick: You can link an optional multime-
dia module to the back of each KVM switch to
select microphone and stereo speaker signals.
There are two options for Audio Stick: ON and
OFF. When set to ON, audio selection follows
computer selection. When set to OFF, audio
selection stops following computer selection.
The ServSwitch beeps once for ON and twice
for OFF. Use this to listen to a particular com-
puter’s audio signal while operating other com-
puters.
Left-Ctrl + Left-Ctrl + A Press this key sequence to select audio for the
chosen computer. (Use when Audio Stick set to
Off.)
Left-Ctrl + Left-Ctrl + U Press this hotkey to select the USB port (for
both 2-port and 4-port ServSwitch).
USB port setting for 2-port ServSwitch:
Left-Ctrl + Left-Ctrl + F7 Press this hotkey to turn ON/OFF the USB1 and
USB2 ports on the console side.
USB port setting for 4-port ServSwitch:
Left-Ctrl + Left-Ctrl +F7 Press this hotkey to turn ON/OFF the USB1 port
on the console side.
Left-Ctrl + Left-Ctrl + F8 Press this hotkey to turn ON/OFF the USB2 port
on the console side.