Filter
Top Products
Hardened VDSL Ethernet Extender
Installation
This chapter gives step-by-step installation instructions for the Hardened VDSL
Ethernet Extender.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not be
subjected to extreme temperatures, humidity, or electromagnetic interference.
Specifically, the site you select should meet the following requirements:
• The ambient temperature should be between -34 to 74 degrees
Celsius.
• The relative humidity should be less than 95 percent, non-condensing.
• Surrounding electrical devices should not exceed the electromagnetic
field (RFC) standards.
• Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes of the equipment.
• The power outlet should be within 1.8 meters of the product.
DIN Rail Mounting
Fix the DIN rail attachment plate to the back panel of the Hardened VDSL Ethernet
Extender.
Installation: Place the Hardened VDSL Ethernet Extender on the DIN rail from above
using the slot. Push the front of the Hardened VDSL Ethernet Extender toward the
mounting surface until it audibly snaps into place.
Removal: Pull out the lower edge and then remove the Hardened VDSL Ethernet
Extender from the DIN rail.
10