Filter
Top Products
Click OK.
6.2.8 Dial in configuration
If the client PC is dialing into Local/Console port on the console server, you will need to set up a dial-in
PPP link:
Configure the console server for dial-in access (following the steps in the Configuring for Dial-In
PPP Access section in Chapter 5, Configuring Dial In Access).
Set up the PPP client software at the remote User PC (following the Set up the remote Client
section in Chapter 5).
Once you have a dial-in PPP connection established, you then can set up the secure SSH tunnel from the
remote Client PC to the console server.
6.3 SDT Connector to Management Console
You can also configure SDT Connector for browser access to the console server’s Management Console
—and for Telnet or SSH access to the command line. For these connections to the console server itself,
you must configure SDT Connector to access the Gateway itself by setting the Gateway (console server)
up as a host, and then configuring the appropriate services:
Launch SDT Connector on your PC. Assuming you have already set up the console server as a
Gateway in your SDT Connector client (with username/ password etc.), select this newly added
Gateway and click the Host icon to create a host. Or, select File -> New Host.
Enter 127.0.0.1 as the Host Address and provide details in Descriptive Name/Notes. Click OK.
_____________________________________________________________________
724-746-5500 | blackbox.com Page 113