Filter
Top Products
RAID Subsystem DVA-08K | Installation Manual Subsystem Maintenance | en 53
Bosch Security Systems F.01U.027.797 | V2 | 2008.08
7. Place the SATA hard drive into the drive tray (as shown in Figure 6.10) making sure that
the hard drive is oriented in such a way that the drive’s SATA connector is facing the back
of the drive tray.
Fig. 6.10 Installing a SATA Hard Drive
8. Adjust the drive’s location until the mounting holes in the drive canister are aligned with
those on the hard drive. Secure the drive with four supplied 6/32 flathead screws. (See
Figure 6.10)
9. If the failed drive is a member of a RAID 1, 3, or 5 array, once it is replaced the subsystem
should immediately start to rebuild the array. The drive activity LEDs should start to flash.
CAUTION!
Only use screws supplied with the drive canisters. Longer screws may damage the drive.