Filter
Top Products
EX36-IP | en 1
Bosch Security Systems Quick Install MAN36IPB Rev.0 | 2008.10
Important safety instructions
Type numbers: NEC-360F02-11 |NEC-360F02-21 |NEC-360F04-11
NEC-360F04-21 INEI-368F04-11 |NEI-368F04-21 |NEI-368F04-11
NEI-368F04-21 INEI-369F02-11 |NEI-369F02-21 |NEI-369F04-11
NEI-369F04-21
Read, follow, and retain all of the following safety instructions. Heed all warnings on
the unit and in the operating instructions.
1. Cleaning - Unpower the unit before cleaning. Follow any instructions provided
with the unit. Generally, using a dry cloth for cleaning is sufficient, but a moist
fluff-free cloth or leather shammy may also be used. Do not use liquid
cleaners or aerosol cleaners.
2. Heat Sources - Do not install the unit near any heat sources such as radiators,
heaters, stoves, or other equipment (including amplifiers) that produce heat.
3. Object and liquid entry - Never push objects of any kind into this unit through
openings as they may touch dangerous voltage points or short-out parts that
could result in a fire or electrical shock. Never spill liquid of any kind on the
unit. Do not place objects filled with liquids, such as vases or cups, on the unit.
4. Controls adjustment - Adjust only those controls specified in the operating
instructions. Improper adjustment of other controls may cause damage to the
unit. Use of controls or adjustments, or performance of procedures other than
those specified, may result in hazardous radiation exposure.
5. Overloading - Do not overload outlets and extension cords. This can cause
fire or electrical shock.
6. Power sources - Operate the unit only from the type of power source indicated
on the label. Before proceeding, be sure to disconnect the power from the
cable to be installed into the unit.
- For external power supplied units, use only the recommended or approved
power supplies.
- For limited power source units, this power source must comply with
EN60950. Substitutions may damage the unit or cause fire or shock.
- For 24 VAC units, voltage applied to the unit's power input should not
exceed 24 VAC. User-supplied wiring must comply with local electrical
codes (Class 2 power levels). Do not ground the supply at the terminals or
at the unit's power supply terminals.
- If unsure of the type of power supply to use, contact your dealer or local
power company.
7. Damage requiring service - Unplug the unit from the main AC power source
and refer servicing to qualified service personnel when any damage to the
equipment has occurred, such as:
- the power supply cord or plug is damaged;