Filter
Top Products
4 en | EX36-IP
MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems
1.1 Unpacking
Parts list (items supplied with unit)
- EX36IP Infrared Imager™ Assembly
- Installation Instructions booklet
- Allen Key
- Software CD
Items required for installation
(not supplied with units)
- Mounting hardware
- Mounting tools
- PC/Laptop with RJ45 Ethernet port
- Power supply
1.2 Initial Preparations
1.) Determine the operating voltage at the installation site. The
camera‘s Voltage Regulator Board accepts 12-24VAC / VDC input
without change to internal connections.
2.) Determine the optimum mounting location for the camera. See
Section 2, Mounting the unit.
3.) All cameras have been tested and pre-focused with telephoto
setting as factory default prior to shipment. If any adjustment
needed, it is advisable to check the camera’s operation before
installation
4.) Install IP Camera Software on PC.
2. Mounting the unit
2.1 Faceplate removal
The faceplate must be removed prior to the installation process.
This is necessary because the mounting holes need to be accessed.
The lens may need to have its directional angle changed.
1.) Place the camera housing on a flat surface.