Filter
Top Products
14 en | Installation Power Supply
AR18-10-B002 | v1.1 | 2010.02 Installation manual Bosch Security Systems
2.4 Connecting the input cable
Figure 2.3 Connecting the input cable
Connect input supply cable as follows:
– Cut back the insulation of the cable wires to approximately
5 mm (0.2 in).
– Pass the input cable through the supplied grommet.
– For each wire, push back the tab behind the terminal with
a small screwdriver and insert the wire (respect the
polarity shown in the figure); release the tab to clamp the
wire in place.
– Secure the grommet firmly.
– Return the protective cover to its position and fasten in
place with the four cross-head screws.
Note:
Tighten screws firmly to ensure protection against water
ingress.
5 mm
(0.2 in)
Live In
Neutral In
Earth In
Input
110-230 VAC
50/60 Hz