Filter
Top Products
Power Supply Installation | en 15
Bosch Security Systems Installation manual AR18-10-B002 | v1.1 | 2010.02
2.5 Connecting the output cables
Figure 2.4 Connecting the output cables
Connect the two output cables as follows:
– Cut back the insulation of the cable wires to approximately
5 mm (0.2 in).
– Pass the output cables through the supplied grommets.
– For each wire, push back the tab behind the terminal with
a small screwdriver and insert the wire (respect the
polarity shown in the figure); release the tab to clamp the
wire in place.
– Secure the grommets firmly.
– Return the protective cover to its position and fasten in
place with the four cross-head screws.
Note:
Tighten screws firmly to ensure protection against water
ingress.
5 mm
(0.2 in)
24 V
24 V
0 V
0 V