Filter
Top Products
Small Size LCD/LED Monitors Navigating the Monitor | en 29
Bosch Security Systems, Inc. User Manual F.01U.134.499 | 1.0 | 2009.07
6.2 Navigating the Monitor On-screen Display
(OSD)
The UML-080-90, UML-100-90, UML-082-90 and the UML-102-
90 have two (2) modes: Video and PC. The LCD is programmed
through the on-screen display (OSD) menus and submenus
where an operator can select operating parameters. To access
the OSD menus, press the Menu button on the front panel. Use
the front panel of the monitor to make any necessary
adjustments to the OSD.
To navigate the set up menus, follow the steps below:
1. Connect the CVBS, S-Video or the VGA cable.
2. Press the Power button to turn on the unit (see
Figure 6.1).
3. If required, press the Input button and the and
buttons until a signal is displayed.
4. Press the Menu button to activate the main menu
selections (see Figure 6.1).
5. Press the and buttons to select a menu.
6. Press the Input button to enter the selected menu.
7. Press the and buttons to select a sub-menu item.
8. Press the Input button to enter the selected sub-menu.
9. Press the and buttons to toggle the OSD values.
10. Press the Menu button to exit the selected menu and to
return to the menu bar or to confirm a selection.
11. Press the Menu button again to exit the OSD menu bar.
NOTICE!
When you are navigating through the OSD menus, use the Input
button to select a menu and use the Menu button to exit a
menu.