Filter
Top Products
17
Using the On-Screen Menus
The projector
has six drop-down menus that allow you to make
image adjustments and change a variety of settings. Most of these
adjustments aren’t available directly from the keypad.
NOTE: Some menu items may be
grayed out at certain times. This
indicates the item is not applicable
to your setup (for example, video
standards do not apply to com-
puter sources) or the item is not
enabled until another selection is
made (for example, Manual Track-
ing is not available until Auto
Image is turned off).
To open the on-screen menus, press the
menu
button on the
keypad. This changes the volume, source, and standby buttons
on the keypad to menu navigation buttons (and illuminates the
keypad green). Press the corresponding buttons to move the
cursor up, down, left, or right. To select a menu, move the cursor
left and right to highlight the menu you want. The drop-down
menu appears.
FIGURE 12
Drop-down menu
To change a menu setting, use the up and down arrow keys on
the keypad to move the cursor up and down to the item you want
to change (the selected item is highlighted red), then use the left
and right mouse buttons (not the left and right arrow buttons) to
adjust a setting. Some submenus, such as Brightness, consist of a
slider bar you use to increase or decrease a value; some sub-
menus, such as Standby Time, consist of options you scroll
through to select the desired one. All changes are saved when
you close the menus.
To access another menu, use the left and right arrow buttons to
move left or right to another menu.