Filter
Top Products
36
Multifunctional settings
OPTION Menu
Item Description
SEARCH
Using the buttons ▲/▼ turns on/off the message function.
TURN ON
TURN OFF
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in order of following. Then when an input
is found, the projector will stop searching and display the image.
If no signal is found, the projector will return to the state before the
operation.
RGB IN1
RGB IN2
COMPONENT VIDEO
S-VIDEO
VIDEO
AUTO OFF
Using the buttons ▲/▼ adjusts the time to count down to
automatically turn the projector off
.
Long (max. 99 minutes)
Short (min. 0 minute = DISABLE)
AUTO OFF
ENABL
E
1
AUTO OFF
DISABLE
0
When the time is set to 0, the projector is not turned off
automatically.
When the time is set to 1 to 99, and when the passed time with
a no-signal or an unsuitable signal reaches at the set time, the
projector lamp will go off and the power indicator begins blinking.
Please refer to the section “Turning off the power”
(
16).
LAMP TIME
The lamp time is the time counted after the last resetting. It is
shown in the OPTION menu as the use time of the lamp.
Pressing the RESET button on the remote control for about 3
seconds displays a dialog. To reset the lamp time, select the
RESET using the button ▲.
RESET
CANCEL
• Please reset the lamp time only when you have replaced the lamp,
for correct messages about the lamp.
• About the lamp replacement, please see the section "Lamp"
(
38, 39).
With the OPTION menu, items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the projector
or remote control, and press the cursor button ► on the
projector or remote control, or the ENTER button on the
remote control to progress
, except for the items LAMP TIME
and FILTER TIME
. Then perform it referring to the following
table.
MENU
[
RGB
]
:SELECT
PICTURE
IMAGE
INPUT
SETUP
SCREEN
OPTION
EASY MEN
U
SEARC
H
AUT
O OFF
LAMP TIME
FILTER TIME
SERVICE
TURN ON
0
0
0