Filter
Top Products
3
6
Turning off the projector
1. Press th e power button on th e pr ojector or r emote contr ol. Th e power off
con fir ma ti on mess ag e app ears .I f you d o n ot wan t to p ower off t h e pr ojector,
ign or e th e message an d it will disappear.
2. Press the power button again and the projector will enter cool-down mode.
The lamp shuts off, the lamp indicator flashes red,and the fans contiune to run for
approximately two minutes.During the cool down sequence the projector will not
respond to any control panel or remote control buttons.
Caution: Do not set the power switch to off or unplug the projector during the
cool-down sequence. Not allowing the lamp to cool properly will greatly reduce
the life of the lamp.
3. After the cool-down sequence is complete the fans will shut off and the lamp
indicator will stop flashing. The projector is now in standby mode and can be
turned back on with the remote control or control panel. If the projector will not
be used for an extended period, set the power switch to off and disconnect the
power cord.