Filter
Top Products
36 Bradyprinter 200M-e and 200M-e 300 User’s Guide
5HPRYLQJWKH/DEHO%DFNLQJ0DWHULDO
NOTE: Since the rewind spindle holds the backing from a
standard-size media roll, we recommend that you perform this
procedure whenever you change the media.
To remove the backing material from the rewind spindle, follow these
steps (you don’t need to turn off the printer for this procedure).
1. Unwind approximately 36" (915 mm) of backing from the rewind
spindle. Cut it off at the spindle.
2. Pull out the hook. Slide the backing material off of the rewind spindle
and discard.
3. Wind the media around the rewind spindle once or twice and reinstall
the hook. Continue winding to remove any slack in the media.
Figure 21