Filter
Top Products
BP-PR PLUS series
Loading media
Edition 7/06 Quick Operator’s Guide 17
6.3 Setting the feed path of the transfer ribbon
Transfer ribbon wrinkling can lead to print image errors. Transfer ribbon deflection can be adjusted so
as to prevent wrinkles. See also “Setting the head locking system” on page 15.
6.4 Removing and installing the rewind guide plate, dispense plate or
tear-off plate
To convert the printer for use in another operating mode, a rewind guide plate, a dispense plate or a tear-
off plate may need to be installed.
The adjustment is best carried out during printing.
Fig. 11: Setting the feed path of the transfer ribbon
1. Read current setting on the scale (1) and
record if necessary.
2. Turn screw (2) with hexagonal wrench and
observe the behavior of the ribbon.
In the + direction, the inner edge of the trans-
fer ribbon is tightened, and the outer edge is
tightened in the - direction.
1
2
For printer versions with a locking system on the rewind assist roller, the locking system on the rewind
assist roller must be removed (see ”6.5” on page 18) for operation in Rewind mode before installation
of the rewind guide plate.
Fig. 12: Removing and installing the rewind guide
plate, dispense plate or tear-off plate
Removing a plate
1. Loosen screws (2) several turns.
2. Slide plate (1) to the right and remove it.
Installing a plate
1. Place plate (1) onto the screws (2) and slide
to the left completely.
2. Tighten screws (2).
2
2
1