Filter
Top Products
22 of 32 Brocade VDX 8770-4 QuickStart Guide
Publication Number: 53-1002554-01
Logging in to the serial console port
Log in to the Brocade VDX 8770-4 through the serial connection with the admin user name. The default password is
password. While you are not required to change the password at the initial login, Brocade recommends that you
change your admin and user passwords. Refer to “Assigning permanent passwords” for more details. Make sure to
write down the new passwords and keep this information in a secure location.
Network OS (8770HOST)
8770HOST console login: admin
Password:
WARNING: The default password of 'admin' and 'user' accounts have not been changed.
Welcome to the Brocade Network Operating System Software
admin connected from 127.0.0.1 using console on 8770HOST
8770HOST#
Changing the RBridge ID
If you are going to have more than one switch in a fabric, each switch must have a unique RBridge ID. The default
RBridge ID for any Brocade VDX 8770-4 is 1. Use the vcs rbridge-id [rbridge-id] command to change the default
RBridge ID. You should be in privileged EXEC mode to run the command.
Enter the vcs rbridge-id [rbridge-id] command.
switch# vcs rbridge-id 2
This operation will change the configuration to default and reboot the switch. Do you want to
continue? [y/n]:y
When the confirmation question appears, answer Y.
The reply to command will include a line about the setting of the RBridge ID.
Successfully set rbridge-id.
3TXD Transmit data
4 GND Logic ground
5Not supported NA
6RXD Receive data
7Not supported NA
8Not supported NA
TABLE 6 Serial cable pinouts
PIN Signal Description