Filter
Top Products
43
The Feed & Cut function is used to feed out 1” (24 mm) of tape and automatically cut it off.
For example, after printing with the Auto cut function set to OFF or when printing has been
interrupted.
To feed and cut off 1” (24 mm) of tape:
● Hold down c and press _ once. 1” (24 mm) of tape is fed out and cut off.
This function can be used to print many copies of the same text while increasing a certain
number in the text by 1 after each label is printed.
To use the Numbering function:
1 Press f, w, h or e to position the cursor below the number that you wish to
increase.
2 Hold down c and press O. The message “NUMBER UNTIL” appears in the display
with the current setting.
☞ To cancel the Numbering function at any time, hold down c and press O (or
press just * ).
3 Use the number keys to type in the last number to be printed.
☞ The last number to be printed can also be selected by pressing h or e.
A number lower than the one that was selected cannot be entered.
4 Press p (or r) to begin printing the labels. The number of each copy is displayed
while it is being printed.
☞ If the Tape margin function is set to any setting other than NONE, a cutting guide (:)
is printed between each label so the tape can be cut to the correct size.
FEED & CUT FUNCTION
NUMBERING FUNCTION