Filter
Top Products
77
CUTTER
ERROR!
• This message appears if the
tape cutter lever is pressed
down while a label is being
printed.
• Turn the P-touch off, then on
again.
INVAL.
CHRS!
• This message appears if the
cursor is not below a number
when you hold down
and press .
• Move the cursor below a
number before holding down
and press .
LENGTH
LIMIT!
• This message appears if the text
is longer than 1 meter when
you try to print.
• Shorten the text to less than 1
meter before trying to print.
• This message appears if the
Length function is used to set
a label length that is less than
1.6” (4.0 cm) or more than
11.8” (30.0 cm).
• Set the label length between
1.6” (4.0 cm) and 11.8” (30.0
cm).
• This message appears if the
Tab Length function is used to
set a tab length that is more
than 11.8” (30.0 cm).
• Set the tab length so that it is
less than 11.8” (30.0 cm).
LINE
LIMIT!
• This message appears if the
number of lines in the text is
greater than the maximum
number of lines possible for
the installed tape.
• Reduce the number of lines or
install a tape of greater width.
MEMORY
FULL!
• This message appears if you
try to store a text file after 300
characters have already been
stored in the memory.
• Delete an unwanted file to
make room for the new one.
NO
FILES!
• This message appears if you try
to recall or delete a text file
from the memory when none
are stored.
• Store a text file first.
Error Message Cause Remedy
Number
Number