Filter
Top Products
6
This machine is equipped with a USB port, allowing you to connect the P-touch to your IBM
PC-compatible or Macintosh computer, and print labels and stamps created using the P-touch
Editor software.
☞
The P-touch Editor software and the printer driver must be installed before the P-touch is
connected to the computer or turned on. Follow the installation procedure on pages 7
through 16 to install the P-touch Editor software and the printer driver, and connect the
P-touch to the computer when you are instructed to do so.
A USB interface cable is not included with the PT-2300. When connecting the P-touch
to a computer, use a standard USB cable (high-speed compatible with series A and B
connectors).
To connect the P-touch to the computer:
1
Insert the flat (A) connector on the USB cable into the USB port on the computer.
2
Insert the square (B) connector on the USB cable into the USB port on the right side of the
P-touch.
3
Turn on the P-touch.
☞
The USB cable needed for connecting the P-touch to the computer is not included. Be
sure to use a cable that meets the following specifications.
CONNECTING THE P-TOUCH TO A COMPUTER
A
A
C
C
C
C
B
B
Overmolded
Series “A” Plug
Overmolded
Series “B” Plug
Detail A-A
(Series
“A” Plug)
Detail B-B
(Series
“B” Plug)
15.7
7.5
10.5
11.5
12.0 12.0
27.0
32.0
9.0
9.0
Optional Molded
Strain Relief