Filter
Top Products
Replacing the correction tape
Two types of correction tape are available:
Lift-off correction tape, to be used correctable
film ribbon.
Cover-up correction tape, to be used nylon ribbon.
To replace the correction tape:
1) Use [SPACE BAR] or H to move the carrier to the
centre of the platen.
2) Open the top cover.
3) Remove the cassette ribbon, if installed.
4) Pull off both spools, pressing against the correction
tape with your thumbs. Bring it back to a position
parallel with the platen, and lift it up and out.
5) Pass the new tape through the left guide, behind the
ribbon guide, and out through the right guide. The
rough (sticky) side of the tape sho@d face the p_aten.
6) Attach the feeder spool to the pin on the left.
7) Attach the take-up spool to the pin on the right.
8) Turn the take-up spool counter-clockwise until a small
amount of white tape has wound around it.
9) Replace the cassette ribbon and close the top cover.
10) Press ]_1+//to move the carrier to the prewous
position.
-Page 11-