Filter
Top Products
4
After completing the setup wizard, your
DriveStation Quattro is installed and ready
to use!
By default, your Quattro is configured in RAID 0 Mode. This gives you
maximum usable capacity and performance, but no redundancy. If a drive
fails, all data on the DriveStation is lost. If you would prefer a different RAID
configuration, you may use the RAID Utility to change your DriveStation’s RAID
settings. Turn to the next page for instructions on using the RAID Utility.
Out of the box, the DriveStation is formatted with FAT32, allowing it to be used
with most common operating systems. If you’re going to use it with programs
that generate filesizes larger than 4GB, such as backup software, reformat the
DriveStation as an NTFS drive.