Buffalo Technology WLI3-TX1-G54 Power Supply User Manual


 
2
System Requirements
Desktop or Notebook computer with an Ethernet (RJ-45) port (for configuration purposes).
Web Browser 5.0 or later.
802.11b or 802.11g access point (Infrastructure Mode) OR a different computer with an
802.11b or 802.11g wireless adapter (Ad-hoc Mode) .
AOSS Installation
If your Wireless Router/Access Point supports Buffalo's AOSS
technology, then it is recommended to use AOSS. If your Wire-
less Router/Access Point does not support AOSS technology,
then please skip to the next page. The following steps will guide
you through the AOSS process.
Plug the Ethernet Converter's AC Adapter into a wall
outlet. Connect the power connector to the back of the Ethernet
Converter.
After 30 seconds, the wireless light on the Ethernet Converter
will become solid. This signifies that the Ethernet Converter
startup process has completed.
Refer to the Ethernet Converter's AOSS supplement to begin the AOSS setup procedure.
AOSS Installation