Filter
Top Products
Page 12
ON/LOWER SWITCH
Placing the "ON/LOWER" switch in the "OFF" (lower) position stops brewing. Stopping a brew cycle after it
has been started, will not stop the flow of water into the funnel until the tank siphons down to its proper level.
Placing the switch in the "ON" (upper) position enables the brew circuit and on all (except APS/TC models) sup-
plies power to the brew station warmer.
START SWITCH
Momentarily pressing and releasing the switch starts a brew cycle. DO NOT HOLD START SWITCH.
NOTE – The "ON/OFF" switch must be in the "ON" upper position to initiate and complete a brew cycle.
NOTE – Some TWINS are equiped with auxiliary brew start switches on each side of brewer. Use care not to
place other items too close to start switches so they don't block or accidently start a brew cycle! FIG 11-1
FLIP LID (POUR IN FEATURE)
Place server under brew funnel. Open flip lid to pour in (water only). DO NOT POUR IN COFFEE!
WARNING: DO NOT USE THE POUR IN FEATURE AND START SWITCH SIMULTANEOUSLY, OVER FLOWING
OF HOT WATER WILL OCCUR!
OPERATING CONTROLS
BREW START SWITCH
ON/LOWER SWITCH
WARMER SWITCHES
FIGURE 12-1
BREW STATION WARMER
BREW FUNNEL
HOT WATER FAUCET
FLIP LID (POUR IN FEATURE)
AUXILIARY BREW START SWITCH
FIGURE 12-2
41721 111308