Filter
Top Products
INSTALLATION
Page 2-3
2.2.1 Unpacking the Adapter
The network adapter and its software are shipped separately. The
complete installation package should contain one conductive
pouch with the adapter and this manual. The software is shipped
in a shrink-wrapped package containing the software, a license
agreement, and a Network Software Installation Guide.
Carefully remove the conductive pouch from the box. Leave the
adapter in the conductive pouch until you are ready to install it.
Open the shrink-wrapped software package when you are ready
to install the software. Be sure to read the license agreement.
CAUTION: The adapter is sensitive to static discharges. Hold it by the
corners. Avoid contact with the PC bus edge connector or any of the
components, except the jumpers. Failure to observe all static precautions
can result in damage to the adapter.
2.2.2 Copying the Software
Before you begin the installation, it is important that you make a
backup copy of the Cabletron software supplied with the adapter.
Use the disk copy routine for your PC to make a duplicate copy of
the Cabletron software diskettes. Store the original software in a
safe place, and use the copies for the actual installation procedure.
2.2.3 Preparing the E1100 for Installation
The E11xx Series employs a socket for an optional Boot PROM. All
parameters except the I/O base address and PROM base address
are set through software. Instructions are included for setting the
I/O base address, and installing the Boot PROM. Figure 2-1, an
E1112 adapter, shows the locations of the jumpers and Boot
PROM socket. Boot PROM addressing is covered in the
installation instructions included with the Boot PROM.