Filter
Top Products
Installing the MicroLAN Module
2-6
Installing the Module into the MMAC-Plus Chassis
MMAC-Plus MicroLAN Modules can be installed in any of the 14 slots that are
available. To install, follow the steps below:
1. Switch off the power supplies and remove all power from the MMAC-Plus
chassis.
2. Remove the blank panels, covering the slots that the module is being
mounted in. All other slots must be covered, if modules are not being
installed, to ensure proper airflow and cooling.
3. Attach one end of the ESD wrist strap packaged with the MMAC-Plus chassis
to your wrist. Plug the other end into the ESD Wrist Strap Grounding
receptacle in the lower right corner of the MMAC-Plus Chassis shown in
Figure 2-4.
4. The module is installed into the chassis by sliding it into slots and locking
down both the top and bottom plastic tabs, as shown in Figure 2-4. Take care
that the module slides in straight and engages the backplane connectors
properly. When installing the module, ensure that both circuit cards are
between the card guides, as shown in Figure 2-4. Check both the upper and
lower tracks of both cards.