Filter
Top Products
Chapter 3: Testing and Troubleshooting
3-4 FOMIM User’s Guide
If failures occur, refer to Section 3.3, Using LANVIEW, in this chapter.
Figure 3-1 Pre-Installation Test
3.3 USING LANVIEW
The FOMIM uses Cabletron Systems built-in visual diagnostic and status
monitoring system called LANVIEW. With LANVIEW, network
troubleshooting personnel can quickly scan LEDs to observe network
status, or diagnose network problems. Figure 1-2 in Chapter 1 shows the
location of the LANVIEW LEDs.
NOTE
A “ping” test will verify that the module is operating properly.
However, both server and client workstations must have their
own unique IP Addresses.
Client Workstation
File Server Workstation
MMAC-M3FNB with IRM3
0494109