Califone PA300+ Wired Projector User Manual


  Open as PDF
of 4
 
Accessories
Wired Microphones
PADM-515
Dynamic, balanced, low impedance (50 ohms) with a cardiod pick-up pattern and comes with a 20’ cable
with XLR phone plug.
PADM-510
Dynamic, unbalanced, high impedance (500 ohms) with a cardiod pick-up pattern and comes with a 20’ cable
with a ¼” phone plug.
Wireless Microphones (for use with PA319 only)
The PA319 is compatible with the Q319 wireless handheld mic. For hands-free operation the M319 Belt Pack transmit-
ter may be used with one of the below microphone types.
CM-316 exible collar mic
HBM-316 headset mic
LM-316 lapel mic
Hardware
TP-30 PresentationPro tripod includes its own carry bag.
PresentationPro Packages
Complete wired and wireless packages are also available online
MB-350 Wall/Tripod Mounting Bracket
The MB-350 bracket and accompanying hardware (included) is used to mount the PA319/PA300+ to the TP-30 tripod or
for wall mounting. Make sure to have a qualied installation professional install the hardware for wall mounting.
Califone will not be held responsible for any damage resulting from improper installation.
5 6
Visit us online at califone.com Visit us online at califone.com
Specications
Rated power output: 30 watts RMS at 2% THD
Sensitivity for rated output: Line: 125 mVrms
Microphone:: 4 mVrms
Auxiliary: 250 mVrms
Frequency response: 60 Hz – 20 kHz+ 3dB
Treble: +10dB, -10dB, 10kHz
Bass: +5dB, -4.5dB 70Hz
Speakers: Woofer: 6” High eciency 4oHms, with non inductive external shield
Tweeter: 2” mylar dome, with crossover capacitor
Crossover: L/C – 6dB/Octave @ 4kHz
Volume control: Steps up/down 4.5 dB per step. 10 steps to maximum volume
Inputs
Line inputs (2): Hi-Z, RCA (summing L+R)
Balanced mic: Hi or lo-Z, with phantom power (+15 volts D.C.)
Unbalanced mic: Lo-Z, ¼” –phone
Auxiliary: Hi-Z Mono ¼” –phone
Line output (2): 750mv constant 2 - RCA, 1 - ¼”
Remote Control distance: 30 Feet
UHF Receiver: 16 selectable channels with switching antennas 902 - 928 MHz
AC Power requirements: 110 – 125 VAC, 50/60 Hz or 208 – 240 VAC, 50/60 Hz
Dimensions (HWD): 6-1/4” x 10” x 8-1/2” (159mm x 250mm x 216mm)
Weight: Actual weight: 10 lbs Shipping weight: 14 lbs
Specications subject to change without notice.
Troubleshooting Guide
Conditions Possible Solution
No sound (power LED not lit): Turn POWER switch on plug in power cord
No sound (power LED lit): Check for output from audio source make sure all cables are completely
plugged in mic switch on increase volume control
Distorted sound: Check input cable connection lower input signal level reduce bass and/or treble
Excessive hum or noise: Use shielded input cable
RC-300 Remote Control does not function: Replace batteries
NOTE: If further questions, contact our technical repair department at 1(800)722-0500 or (818)407-2400
 previous