Filter
Top Products
9
Users in the U.S.A.
Preinstallation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine. See “Speci cations” in this guide for speci c dimensions and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary) should be used. If the Super G3 2nd Line Fax Board is installed, a multi telephone line (touch-
tone or rotary) can be used.
2. Order an RJ11-C telephone wall jack (USOC), which should be installed by the telephone company. If the RJ11-C wall jack is not present,
telephone/facsimile operation is not possible.
3. Order a normal business line from your telephone company's business representative. The line should be a regular voice grade line or an
equivalent one. Use one line per unit. If the Super G3 2nd Line Fax Board is installed, you can use a multi-line.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you communicate overseas
Canon recommends an individual line following industry standards, i.e., 2500 (touch-tone) or 500 (rotary/pulse dial) telephones.
A dedicated extension o a PBX (Private Branch eXchange) unit without "Call Waiting" can be used with your facsimile unit.
Key telephone systems are not recommended because they send nonstandard signals to individual telephones for ringing and
special codes, which may cause a facsimile error.
C. Power Requirements
The machine should be connected to a standard 120 volt AC, three-wire grounded outlet only.
Do not connect this machine to an outlet or power line shared with other appliances that cause "electrical noise." Air conditioners, electric
typewriters, copiers, and machines of this sort generate electrical noise that often interferes with communications equipment and the sending
and receiving of documents.
Connection of the Equipment
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the rear panel of this equipment is
a label that contains, among other information, a product identi er in the format of US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
The REN (Ringer Equivalence Number) is used to determine the number of devices that may be connected to a telephone line. Excessive RENs
on a telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should
not exceed ve (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local
telephone company. The REN for this product is part of the product identi er that has the format US:AAAEQ##TXXXX. The digits represented by
## are the REN without a decimal point (e.g., 10 is a REN of 1.0).
An FCC compliant telephone line cable and modular plug is provided with this equipment. This equipment is designed to be connected to the
telephone network or premise wiring using a compatible modular jack that is Part 68 compliant.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tari s.
In Case of Equipment Malfunction
Should any malfunction occur which cannot be corrected by the procedures described in the e-Manual, disconnect the equipment from the
telephone line cable and disconnect the power cord. The telephone line cable should not be reconnected or the main power switch turned
ON until the problem is completely resolved. Users should contact their local authorized Canon Facsimile Service Dealer for the servicing of
equipment.
If your equipment malfunctions, please contact your local authorized Canon dealer from whom you purchased the equipment (if under
warranty), or with whom you have a servicing contract. If you are not sure who to contact, and have both purchased and are using the
equipment in the U.S.A., please refer to the "SUPPORT" page on Canon U.S.A.'s Web site (http://www.usa.canon.com).
Rights of the Telephone Company
If this equipment imageRUNNER ADVANCE C2030/C2020 causes harm to the telephone network, the telephone company may temporarily
disconnect service. The telephone company also retains the right to make changes in facilities and services that may a ect the operation of
this equipment. When such changes are necessary, the telephone company is required to give adequate prior notice to the user. However,
if advance notice is not possible, the telephone company will notify the customer as soon as possible. Also, the customer will be advised of
his/her right to le a complaint with the FCC if he/she believes it is necessary.